← Back to team overview

kicad-developers team mailing list archive

Re: Converting KiCAD to metric units: The approach


On Tue, 28 Jun 2011, Dick Hollenbeck wrote:
Why less legible file format?   I am not arguing for tens of nm, I am saying
that that decision has no bearing on file format human readability.

The 'slightly' was 'slightly' ironic... it's only 'more' intuitive in nm
than in tens on nm. Of course at the end it's exactly the same :D

Are we no longer in agreement that we will be saving these interim board files
in either mm or mils?

I wouldn't care less of the actual unit used. Everything that's needed
is already in place, so we just have to decide. The mm/mil syntax would
be fine for me

Lorenzo Marcantonio
Logos Srl

Follow ups