kicad-developers team mailing list archive
-
kicad-developers team
-
Mailing list archive
-
Message #08586
Re: Circular interpolation in gerbers
On Fri, Jul 13, 2012 at 04:15:43PM -0400, Wayne Stambaugh wrote:
> Thanks for stepping up and adding circular interpolation support to
> Pcbnew. I know some folks will be concerned about board houses that
> don't support the G02/G03 codes but I would think they would be far
> and few in between. I doubt there are many (any?) board vendors in
> the US that do not support this.
I'm 99% positive that there is no fabricator which couldn't handle G02 or G03...
Unless it requests an aperture file; in that case run away...*fast* XD
--
Lorenzo Marcantonio
Logos Srl
References