kicad-developers team mailing list archive

[jp charras <jp.charras@xxxxxxxxxx>]

Le 07/02/2018 à 19:44, Wayne Stambaugh a écrit :
> If you are using a gal canvas, the only time you see the cross hairs is
> when a tool is selected.  This is true of even the small cross hairs.

Yes, but if in Preferences/Display Options you enable "Always display crosshairs" you should have
the crosshair cursor always displayed.

> 
> On 2/7/2018 1:41 PM, Bernhard Stegmaier wrote:
>> Yes, did see the button (synced today).
>> But it didn’t seem to change anything.
>> Where should I see it?
>>
>>> On 7. Feb 2018, at 19:39, Jeff Young <jeff@xxxxxxxxx> wrote:
>>>
>>> The crosshairs should be available again in a current build.  Do you see the toolbar button on the left?
>>>
>>>> On 7 Feb 2018, at 17:36, Bernhard Stegmaier <stegmaier@xxxxxxxxxxxxx> wrote:
>>>>
>>>> … yes, no good.
>>>> It seems to be OK when just panning around.
>>>> But, it gets very laggy while e.g. dragging/moving symbols around (even on a not so big schematic I had at hand).
>>>>
>>>> It is fine if you take out the Refresh() quoted below on macOS.
>>>> I didn’t see any obvious things on a quick check with the remaining changes (might be due to the fact that crosshair is still disabled on macOS?).
>>>>
>>>>
>>>> Regards,
>>>> Bernhard
>>>>


-- 
Jean-Pierre CHARRAS