ubuntu-phone team mailing list archive

[Chan Ju Ping <email@xxxxxxxxx>]

Finally managed to get the ubports image flashing on my M10 FHD!

Thanks for the MDT method and the clear instructions. I will get on with the 
Patreon sponsoring ASAP.

On Thursday, 11 May 2017 19:39:40 +08 Chan Ju Ping wrote:
> Thing is it is incredibly difficlt to enter recovery.
> 
> I hold down power and vol-down as this guide suggests:
> 
> https://forum.xda-developers.com/general/rooting-roms/root-bq-aquaris-x5-plu
> s-gohan-t3485161
> 
> And it is only after 10 minutes or so that it enters the bootloader screen.
> Even so, running fastboot devices returns nothing.
> 
> What is the consistent way to get it to recognise fastboot, and thereafter,
> if I have "frieza-image-stable-8.zip", is the right command "fastboot flash
> recovery frieza-image-stable-8.zip" ?
> 
> On Thursday, 11 May 2017 5:32:22 PM +08 linuxgehtned@xxxxxxxxxxxxxxxx 
wrote:
> > Or better fastboot. German Ubuntuusers wiki describes fine.
> > 
> > Am Donnerstag, 11. Mai 2017 11:29:39 CEST schrieb
> > 
> > linuxgehtned@xxxxxxxxxxxxxxxx:
> > > Recovery mode, look online or try key kombination of bq 4.5, documented
> 
> on
> 
> > > some sites.
> > > 
> > > Benno-007
> > > 
> > > Am Donnerstag, 11. Mai 2017 11:24:23 CEST schrieb Chan Ju Ping
> > > 
> > > <email@xxxxxxxxx>:
> > >> What do I do if I can't boot into Ubuntu to do an adb
> > >> connection? Is there a
> > >> way to flash the image to my tablet?
> > >> 
> > >> On Thursday, 11 May 2017 11:43:43 AM +08 Chan Ju Ping wrote:
> > >>> Great! Thanks!
> > >>> 
> > >>> On Thursday, 11 May 2017 6:38:33 AM +08 NeoTheThird wrote:
> > >>> > The UBports image for the M10 should be ready soon, until
> > >>> 
> > >>> then, you can
> > >>> 
> > >>> > just try flashing the bq image:
> > >>> http://www.mibqyyo.com/en-download/categorias/aquaris-m10-fhd-ubuntu-e
> > >>> di
> > >>> ti
> > >>> 
> > >>> > on /
> > >>> > 
> > >>> > On 10.05.2017 05:59, Chan Ju Ping wrote:
> > >>> > > My M10 displays "powered by ubuntu" white screen when it
> > >>> 
> > >>> boots up, then
> > >>> 
> > >>> > > goes to the progress bar load for Ubuntu but stops there.
> > >>> > > 
> > >>> > > I switched to the dev channel and it seems this is what I am 
stuck
> > >> 
> > >> with.
> > >> 
> > >>> > > What can I do to make it functional again? Are the
> > >>> 
> > >>> community ports for
> > >>> 
> > >>> > > the
> > >>> > > M10 ready to roll yet? Even in an alpha capacity?

Attachment: signature.asc
Description: This is a digitally signed message part.