kicad-developers team mailing list archive

[Wayne Stambaugh <stambaughw@xxxxxxxxx>]

Is anyone else have an issue with the track width and via diameter combo
boxes in the auxiliary tool bar not being populated with the board
design rules information?  I just noticed this because I added some
dummy design rules so I could change the width of some of my ground
traces and noticed that only the default track width and via diameters
are available.  It looks like the design rule settings are being
ignored.  I tried closing and reopening Pcbnew, restarting KiCad
completely, and running Pcbnew in stand alone mode but no luck.  I seem
to remember this issue being fixed several times in the past.  I was
just wondering if it's a problem on windows or a problem in general.

Wayne