kicad-developers team mailing list archive

[Seth Hillbrand <seth@xxxxxxxxxxxxx>]

Whoops!  Excuse me while I go face-palm...

Thanks for checking this.

-Seth

On 2019-07-16 10:38, Jeff Young wrote:
> Hi Seth,
>
> We’re not adding that curve; it’s in the Eagle file:
>
> <polygon width="0.1524" layer="1" spacing="0.6096" isolate="0.3048" 
> rank="2">
> <vertex x="102.108" y="53.848"/>
> <vertex x="102.108" y="-0.508"/>
> <vertex x="-1.016" y="-0.508"/>
> <vertex x="-1.016" y="52.832" curve="-89.13168"/>
> <vertex x="0" y="53.848"/>
> </polygon>
>
>
> > On 16 Jul 2019, at 13:43, Seth Hillbrand <seth@xxxxxxxxxxxxx> wrote:
> >
> > Hi Jeff-
> >
> > That one was the Due reference design [1] but for me it happens on all 
> > Eagle zones.
> >
> > -Seth
> >
> > [1] https://content.arduino.cc/assets/DUE-reference.zip
> >
> > On 2019-07-16 08:16, Jeff Young wrote:
> > > Hi Seth,
> > > I’m not seeing the same behaviour.  Could you send me the Eagle file
> > > you were using for that screen-shot?
> > > Thanks,
> > > Jeff.
> > > > On 16 Jul 2019, at 12:47, Jeff Young <jeff@xxxxxxxxx> wrote:
> > > > Actually, something fishy is going on with the MiterLimit.  It
> > > > should be rounding the fill, but not the outline (even in strategy
> > > > (a))….
> > > > On 16 Jul 2019, at 10:12, Jeff Young <jeff@xxxxxxxxx> wrote:
> > > > We need to go to strategy (b) to fix that (use the zone’s fillet
> > > > radius to round the corners).
> > > > I’ll look into it….
> > > > On 16 Jul 2019, at 02:37, Seth Hillbrand <seth@xxxxxxxxxxxxx> wrote:
> > > > Hi Jeff-
> > > > I just checked a couple of Eagle boards and the imports are now
> > > > slightly problematic.  See the attached image.  This corner is
> > > > square in Eagle.  It can be very difficult to edit zones with a
> > > > bunch of extra points, so I'd like to avoid this if possible.
> > > > Best-
> > > > Seth
> > > _______________________________________________
> > > Mailing list: https://launchpad.net/~kicad-developers
> > > Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> > > Unsubscribe : https://launchpad.net/~kicad-developers
> > > More help   : https://help.launchpad.net/ListHelp